Dizel Motor Egzoz Sistemi için Termoelektrik Jeneratör Uygulaması ve Akış Analizi
Abstract
Bu çalışmada, termoelektrik jeneratörlerin çalışma prensiplerine uygun bir prototip geliştirilmiştir. Isıtılacak yüzey için bir dizel motorunun egzoz sistemi kullanılmış ve motorun çalışması sonucu açığa çıkan egzoz gazlarının ısı enerjisinden faydalanılmıştır. Termoelektrik modüllerde (TEM) fark sıcaklığının oluşmasında ihtiyaç duyulan soğutma ise motordan harici bir soğutma sistemi tarafından gerçekleştirilmiştir. Bu sistem 20 Watt gücünde anlık elektrik enerjisi ihtiyacı ile çalışmaktadır. Alüminyum 6061 malzemesinden oluşan sekizgen yapıya montajı gerçekleştirilen termoelektrik modüller kendi aralarında elektriksel olarak seri bağlanmıştır. Termoelektrik jenaratör (TEJ) sisteminin ürettiği maksimum elektriksel çıkış gücü motorun 3500 dak-1 devir ve 100 Nm yükte çalışma şartlarında 156.7 Watt olarak kaydedilmiştir. Elde edilen elektriksel güç DA/DA konvertöre iletilerek boş bir akünün şarj işlemi gerçekleştirmiştir. Daha sonra sistemin, Ansys Workbench 12.0 içinde yer alan ve aynı zamanda Hesaplamalı Akışkanlar Dinamiği (HAD) yazılımı olan Fluent programı yardımıyla akış analizleri gerçekleştirilmiştir. In this study, A prototype has been developed as the working principle of thermoelectric generators. The exhaust system of a diesel engine used for the surface will be heated and as a result of operation of the engine profit by heat energy of the exhaust gases. Required cooling effect in the occur of the different temperature of thermoelectric modules (TEM) is realised by an cooling system without engine. Reguired electric power of this system is 20 Watt as instant. Electrically are connected as series with each other thermoelectric modules realised assembly octagonal structure consisted from the aluminum 6160 material. The maximum electrical output power produce of the thermoelectric Generation (TEG) system is registered as 156.7 Watt at the 3500 rpm and 100 Nm as of the engine working condition. The discharged battery charging is performed with electrical power supplied to DC / DC converter. Then in the system, heat-flow analysis was realised with the help Fluent which contained in the Ansys Workbench 12.0 and in the same time meaning Computational Fluid Dynamics (CFD) software.
Source
Afyon Kocatepe Üniversitesi Fen ve Mühendislik Bilimleri DergisiVolume
16Issue
2URI
http://www.trdizin.gov.tr/publication/paper/detail/TWpBNU1ESTFOUT09https://hdl.handle.net/20.500.12418/4040
Collections
- Makale Koleksiyonu [3404]
- Öksüz Yayınlar Koleksiyonu - TRDizin [3395]