Investigation on the machinability of steel/steel laminates by CO2 laser

Basit Öğe Kaydı
dc.contributor.authorSimsir, Mehmet
dc.contributor.authorOzer, Ali
dc.contributor.authorKumruoglu, Levent Cenk
dc.date.accessioned2019-07-27T12:10:23Z
dc.date.accessioned2019-07-28T09:58:06Z
dc.date.available2019-07-27T12:10:23Z
dc.date.available2019-07-28T09:58:06Z
dc.date.issued2014
dc.department[Simsir, Mehmet -- Ozer, Ali -- Kumruoglu, Levent Cenk] Cumhuriyet Univ, Dept Met & Mat Engn, TR-58140 Sivas, Turkeyen_US
dc.description.abstractIn this study, an experimental investigation of machinability of steel/steel laminates using CO2 laser was presented. O-2 assist gas was used for cutting of laminates. Laser power and feed rate were changed gradually as cutting parameters. Heat affected zone (HAZ) size and kerf width were measured. Effect of linear energy density (ratio of power to feed rate) was determined on the kerf width, the HAZ size, and the cutting surface quality. Also, the quality of surface was examined under optical microscopy, and scanning electron microscopy. It is concluded that when linear energy density is increased, the kerf width and the HAZ size increase. Dross formation and surface irregularities increase with increasing laser power and decreasing feed rate.en_US
dc.identifier.doi10.1504/IJMPT.2014.059032en_US
dc.identifier.endpage94en_US
dc.identifier.issn0268-1900
dc.identifier.issn1741-5209
dc.identifier.issue01.Apren_US
dc.identifier.scopus2-s2.0-84893930800en_US
dc.identifier.scopusqualityQ3
dc.identifier.startpage80en_US
dc.identifier.urihttps://dx.doi.org/10.1504/IJMPT.2014.059032
dc.identifier.urihttps://hdl.handle.net/20.500.12418/8435
dc.identifier.volume48en_US
dc.identifier.wosWOS:000331091300006en_US
dc.identifier.wosqualityQ4
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherINDERSCIENCE ENTERPRISES LTDen_US
dc.relation.ispartofINTERNATIONAL JOURNAL OF MATERIALS & PRODUCT TECHNOLOGYen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectCO2 laseren_US
dc.subjectcomposite materialsen_US
dc.subjectkerf widthen_US
dc.subjectheat affected zoneen_US
dc.subjectHAZen_US
dc.subjectsurface qualityen_US
dc.subjectmaterials and product technologyen_US
dc.titleInvestigation on the machinability of steel/steel laminates by CO2 laseren_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu